DCS CT-304 Instalační příručka stáhnout pdf (Strana 10)

INSTALLING DOWNDRAFT

(continued)

The lower support legs have

holes for mounting to the

cabinet floor and can be

installed on both sides

depending upon the length

required. Determine if the

holes should be in the front or

on the sides.

3) Carefully insert the unit into

the cutout. Due to the size and

weight, two people are

recommended when lifting

this unit. Make sure that the

downdraft is fully seated in the

cutout and the support arms

rest firmly on the countertop.

4) Adjust the lower support legs

until both rest firmly on the

cabinet floor. Place a level

vertically on the front side of

the blower box to make sure

that the unit is level and not leaning to

the front or rear. Once the unit is properly

aligned,mark a starter hole on the cabinet

floor where the lower support legs will

attach to the cabinet floor.

5) Remove the unit from the cabinet. Drill

starter holes in the cabinet floor for the

leg screws.

6) DCS downdrafts are shipped from the

factory ready to vent in the down

position. If you need to vent back, left or

right, then the blower must be reposi-

tioned.

To vent to the left or the right:

Four hex nuts attach the blower box to the

downdraft body. Remove all four nuts and

carefully remove the blower box. To vent left

or right, simply rotate the blower box 90° to

the left or right and re-assemble.

To vent to the rear:

Venting to the rear requires that the blower be

repositioned inside the blower box as

indicated in Fig. 09. The blower is attached to the blower box by 6 screws. Remove the blower from

the blower box. Note the position of the angle mounting rails on each side of the blower. To vent to

the rear, both mounting rails must be repositioned on the blower as illustrated in Fig. 10. Attach the

mounting rails as indicated. Re-attach the blower to the blower box. Re-attach the blower box to

end cap

LOWER SUPPORT LEGS

UNDER COUNTER

MOUNT BRACKETS

OVER COUNTER

SUPPORT ARMS

Venting Left, Right or Down

Venting to the Rear

INSTALLATION INSTRUCTIONS

FIG.08

FIG.09

FIG.10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Komentáře k této Příručce

Žádné komentáře

DCS CT-304 Instalační příručka Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Sporáky DCS CT-304