DCS CT-304 Instalační příručka

THE PROFESSIONAL DOWNDRAFTInstallation GuideMODELS: DD-36SS DD-30SS

9INSTALLING DOWNDRAFT (continued)The lower support legs haveholes for mounting to thecabinet floor and can beinstalled on both sidesdepending upon the

10INSTALLING DOWNDRAFT (continued)the downdraft. The square metal frame must be attached to the mouth of the blower. The exhaustknockout on the rear m

11INSTALLING DOWNDRAFT (continued)13) Connect the ductwork to the Backdraft damper. Seal all joints with duct tape and vent to theoutside of the home.

12WIRING DIAGRAM GEAR MOTORBLUWHTWHTBLKWHTBLKBLKBLKWIRING BOX LINE IN120 VAC60 HzGRNWHTISWITCH DOWN N.C.SWITCH UP N.C.BLK BLKBLK BLKBLKBLK

13SERVICEHOW TO OBTAIN SERVICE:Before you call for service:1) Is the circuit breaker tripped or the fuse blown?2) Is there a power outage in the area?

14WARRANTYLIMITED WARRANTYWhen you purchase a new DCS Ventilation Product for personal or consumer use you automaticallyreceive a One year Limited War

15WARRANTY7. Noise or vibration that is considered normal, for example, drain/fan sounds, regenerationnoises or user warning beeps.8. Correcting damag

Fisher & Paykel Appliances, Inc.5900 Skylab Road, Huntington Beach, CA 92647 Customer Care: 888.281.5698Fax: 714.372.7003 www.dcsappliances.comP

1A MESSAGE TO OUR CUSTOMERSThank you for selecting this DCS Downdraft Vent System. Because of its unique features,we have developedthis Installation G

2TABLE OF CONTENTSSAFETY PRACTICES & PRECAUTIONS ...

3SAFETY PRACTICES & PRECAUTIONSWARNING:ALL WALL AND FLOOR OPENINGS WHERE THE Downdraft IS INSTALLED MUST BE SEALED.Consult the cooktop installatio

4PLANNING THE INSTALLATIONVENTING REQUIREMENTSDetermine which venting method is best for your application. Ductwork can extend either throughthe wall

5SPECIFICATIONS17-3/16"4-1/8" 10"3-1/4"23-9/16"3/8" 4-1/8" 1/2" min.+ 1/2 "min.+3/8"17-9/16"4-1

45° Elbow 5.0 feet90° Elbow 7.0 feet90° Flat Elbow 12.0 feetWall Cap 0.0 feet6INSTALLATION INSTRUCTIONSTOOLS NEEDED FOR INSTALLATION PARTS SUPPLI

7PLAN AND MAKE THE CUTOUTIt is recommended that the installer draw the cooktop and downdraft cutouts on the countertopbefore making any cutouts to avo

8INSTALLING DOWNDRAFT VENT1) Remove the unit from the cartonand place on a flat surface forassembly. Cover the surface toprevent accidental damage.Rem