DCS RDV364GDL Instalační příručka stáhnout pdf (Strana 12)

UNPACKING AND HANDLING

MOVING AND PLACING THE RANGE cont.)

Anti-tip device should be installed (see section ‘Installing anti-tip

device’ for instructions). The professional range should be

transported by a dolly close to its final location. The range can

be tipped back and supported on the rear legs while the dolly is

removed. The floor under the legs should be protected (wood

strips, carpet, paneling, etc.) before pushing the unit back into

position.

Electric and gas connections should be made before the range is

slid into the cabinet opening (see sections ‘Electrical connections’

and ‘Gas hook-up’). If installing a full backguard with the range,

it should also be installed before the range is placed in its final

position (see sections ‘Planning the installation’ and ‘Backguard

installation’). For proper performance, the professional range

should be level. Flooring in cabinet opening must be at the

same level as flooring located in front of the cabinets. To achieve

a flush fit of the range to adjoining countertops, it will be

necessary to have level cabinets (front to back, and left to right

across opening of the range). After checking the countertops

for level and before sliding the range into place, measure the

distance from the floor to the top of the counter work surface

in the rear left and right corners. Adjust the corresponding rear

corner of the range to an equal height of the counter, as the rear

leveling legs are not accessible once the range is pushed into

place. Once the range is in place, the front leg levelers can be

accessed to level the front of the range. Replace the kick panel

and oven doors by reversing the procedure described further

below. It is important that the two screws retaining the kick

panel are secure to prevent accidental access to live electrical

components and wires (Fig. 2a).

To remove the kick panel:

Remove two screws at the top and pull forward. The range is

held to the skid by two bolts (RGU/RGV/RDU/RDV models) or

by L-brackets (RGUC/RGVC models) in the front, behind the

kick panel, and two L-brackets located on the bottom flange

of the range back (Fig. 2b). After removing the bolts and

brackets, the range must be lifted and removed from the skid.

Due to the weight, a dolly with soft wheels should be used

to move this unit. The weight must be supported uniformly

across the bottom (Fig. 3).

CAUTION: RGUC/RGVC MODELS ONLY

Before using the range, be sure to remove shipping spacer

insert in the broiler (see Fig. 4).

Left Rear Shipping

Screws

Fig. 2b

Fig. 4

Left Rear

Shipping Screws

22"

Leveling Legs

Range Must

be Uniformly

Supported

on Braces

Fig. 3

Range Must

be Uniformly

Supported on

Braces

Leveling Legs

Fig. 2a

Kick Panel

Shipping

Spacer

Kick Panel

(RDV, RGV & RGVC models)

(RDU, RGU & RGUC models)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Komentáře k této Příručce

Žádné komentáře

DCS RDV364GDL Instalační příručka Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Sporáky DCS RDV364GDL