DCS RDT-366SS Instalační příručka stáhnout pdf (Strana 6)

PLANNING THE INSTALLATION

RECOMMENDED INSTALLATION INSTRUCTION

Install components in the following order:

A) Vent Hood

B) Backguard System

C) Range

1) Locate and level range according to range installation instructions.

2) Measure distance from floor to top of island trim on range adding 1/8”for backguard clearance.

3) Transfer this measurement to the wall. This will mark the bottom of your backguard.

4) From this line measure 28” up wall to mark top of 30” backguard. This is the minimum height

that the bottom of your vent hood can be installed.

6) Follow vent hood manufacturer’s installation instructions to install vent hood.

7) Follow backguard installation instructions to install backguard.

8) Connect gas and electric connections and slide range into position.

STEP 1:

MOVING AND PLACING THE RANGE

The ranges have shipping weights varying from

380lbs. to 600lbs. After removal of packing material,

it is recommended that the door(s), grates, front kick

panel, and drip pan (below knobs) be removed to

facilitate handling. This will reduce the weight for

ease of handling.

UNPACKING AND HANDLING

Kick Panel

Fig. 1

1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Žádné komentáře

DCS RDT-366SS Instalační příručka Strana 6